Reveal fingerprints using soot!
- Conduct the experiment on the plastic tray.
- Keep flammable objects and hair away from flame.
- Keep a bowl of water nearby while working with fire.
- Do not allow chemicals to come into contact with the eyes or mouth.
- Keep young children, animals and those not wearing eye protection away from the experimental area.
- Store this experimental set out of reach of children under 12 years of age.
- Clean all equipment after use.
- Make sure that all containers are fully closed and properly stored after use.
- Ensure that all empty containers are disposed of properly.
- Do not use any equipment which has not been supplied with the set or recommended in the instructions for use.
- Do not replace foodstuffs in original container. Dispose of immediately.
- In case of eye contact: Wash out eye with plenty of water, holding eye open if necessary. Seek immediate medical advice.
- If swallowed: Wash out mouth with water, drink some fresh water. Do not induce vomiting. Seek immediate medical advice.
- In case of inhalation: Remove person to fresh air.
- In case of skin contact and burns: Wash affected area with plenty of water for at least 10 minutes.
- In case of doubt, seek medical advice without delay. Take the chemical and its container with you.
- In case of injury always seek medical advice.
- The incorrect use of chemicals can cause injury and damage to health. Only carry out those experiments which are listed in the instructions.
- This experimental set is for use only by children over 12 years.
- Because children’s abilities vary so much, even within age groups, supervising adults should exercise discretion as to which experiments are suitable and safe for them. The instructions should enable supervisors to assess any experiment to establish its suitability for a particular child.
- The supervising adult should discuss the warnings and safety information with the child or children before commencing the experiments. Particular attention should be paid to the safe handling of acids, alkalis and flammable liquids.
- The area surrounding the experiment should be kept clear of any obstructions and away from the storage of food. It should be well lit and ventilated and close to a water supply. A solid table with a heat resistant top should be provided
- Substances in non-reclosable packaging should be used up (completely) during the course of one experiment, i.e. after opening the package.
FAQ and troubleshooting
Make sure your hands are clean and dry. Place any finger in the center of the rectangle, keeping everything in-frame. Press down hard. Try not to touch the paper with your other fingers – this could hinder the experiment in the future. If the fingerprint isn’t clear, try rubbing your finger on your forehead to make your finger more oily, and then leaving a new fingerprint. This should help you make a clear print.
Don’t worry! Just continue the experiment.
If you look closely, you’ll notice that the foil from the set is much thicker than ordinary foil. Unfortunately, this makes it difficult to replace with foil from another source. We strongly recommend using the foil we provide – it should suffice to repeat the experiment several times. Moreover, you can use a single piece of foil multiple times for this experiment.
Perform this experiment without gloves.
For this experiment, you’ll need soot. You can use a candle as a source.
Soot is a form of carbon, and is produced when paraffin doesn’t burn completely. Use a piece of foil to collect some soot.
Reveal the fingerprint using the soot you’ve collected. Try collecting your relatives' and friends' prints too!
Dispose of solid waste together with household garbage.
Curiously, carbon is a single element that can comprise quite a few compounds. Take, for instance, graphite, diamond, fullerenes, even carbon nanoparticles – all of these are elementary substances made of only carbon atoms !
Graphite, while more compact than soot, has a layered structure that forms easily-separable “slices.” Graphite is thus able to leave traces on paper, making it useful in pencils. Another well-known carbon compound—diamond—has a well-packed, regular structure, which gives it outstanding strength and a characteristic brilliance. Cubic zirconia has similar optical properties—use your piece for reference!